Summary:The use of the wire connector is very simple. We strip the insulation layer of about 10mm from the wire according to the nominal length, then lift the...
The use of the
wire connector is very simple. We strip the insulation layer of about 10mm from the wire according to the nominal length, then lift the operating rod, put the wire into the connector and release the operating rod. Compared with the method of connecting with electrical tape, connecting wires with connectors is safer and more reliable, and the operation is simpler and more convenient. It has the advantages of flame retardant, pressure resistance, insulation, simple operation, firm connection, direct current transfer between wires, strong versatility, and long service life.
When renovating indoor circuits, the wires usually go to the floor and the wall; however, when we are wiring the kitchen and bathroom, the circuit is best to go to the wall and the top. The ceilings of bathrooms and kitchens cannot be slotted. After installing the wiring on the ceiling, cover it with a suspended ceiling. When we slot the circuit, we should pay attention that we cannot slot the load-bearing wall; when slotting the wall, it should be slotted vertically. If vertical slotting is required on the wall, the horizontal slotting length should not exceed 30cm.
During circuit modification, there must be no joints in the electrical conduit. If wire connections are required, they can be made in the junction box. The strong current and the weak current are different from the same wire tube, and the wiring should be separated and kept at a distance of 500mm, so as to prevent the strong current from causing electromagnetic interference to the weak current. When carrying out the circuit layout, we also need to take into account the use of electrical appliances in the home, and appropriately increase the line capacity; and reserve some switch sockets to avoid insufficient sockets for electrical appliances in the future.
English
